GN Drilling Waste Management Systems
GN Solids Control has many experience engineers in waste management area. In order to meet the demands of environment protection and make money from the waste oil, using GN drilling waste management systems would be one cost effective method.
GN drilling waste management systems is a pretty standard system mainly including one GN cuttings dryer and one decanter centrifuge, two positive pumps (one for cleaning and flushing the cuttings dryer when the work is finished, the other one is used for feeding mud into the decanter centrifuge), skid and tank as well as some other auxiliary equipments such as ladders, walkways, guiderails and lights etc.
In order to operate GN drilling waste management systems conveniently, GN designers take the working conditions into consideration. The whole systems are pretty compact, while the operators have large room for work.
GN cutting dryer is quite effective for OBM, WBM or SBM treating. When using GN dryer, on one hand you can separate the solids out from the waste mud, on the other hand you can reclaim some precious oil which can be used for further treatment and sell to make profit. From this point, treat the waste oil can reach the aim of protecting environment and make money.
Solids come out from the waste mud contain a little bit oil, according to the discharge standard, these solids can be discharged directly without any further treatment due to the oil is less than 5 percent.
As to the WBM treating, GN dryer also can perform excellently. Solids usually contain less than 10% water. These solids can be transported to other places after 2 or 3 days nature dry.
Fluids come out from cuttings dryer can be sent to decanter centrifuge for further separation. All the solids larger than 2 or 3 microns can be separated out.
GN drilling waste management system can also working in harsh environment which is very cold. Last December, some sets of GN drilling waste management systems are using in Russia, where the temperature is minus 40 ℃.

GN Solids Control has many experience engineers in waste management area. In order to meet the demands of environment protection and make money from the waste oil, using GN drilling waste management systems would be one cost effective method.
GN drilling waste management systems is a pretty standard system mainly including one GN cuttings dryer and one decanter centrifuge, two positive pumps (one for cleaning and flushing the cuttings dryer when the work is finished, the other one is used for feeding mud into the decanter centrifuge), skid and tank as well as some other auxiliary equipments such as ladders, walkways, guiderails and lights etc.
In order to operate GN drilling waste management systems conveniently, GN designers take the working conditions into consideration. The whole systems are pretty compact, while the operators have large room for work.
GN cutting dryer is quite effective for OBM, WBM or SBM treating. When using GN dryer, on one hand you can separate the solids out from the waste mud, on the other hand you can reclaim some precious oil which can be used for further treatment and sell to make profit. From this point, treat the waste oil can reach the aim of protecting environment and make money.
Solids come out from the waste mud contain a little bit oil, according to the discharge standard, these solids can be discharged directly without any further treatment due to the oil is less than 5 percent.
As to the WBM treating, GN dryer also can perform excellently. Solids usually contain less than 10% water. These solids can be transported to other places after 2 or 3 days nature dry.
Fluids come out from cuttings dryer can be sent to decanter centrifuge for further separation. All the solids larger than 2 or 3 microns can be separated out.
GN drilling waste management system can also working in harsh environment which is very cold. Last December, some sets of GN drilling waste management systems are using in Russia, where the temperature is minus 40 ℃.